Ken Cavanaugh wrote:
>
> On Mar 5, 2009, at 9:46 AM, Sahoo wrote:
>
>> Ken Cavanaugh wrote:
>>>
>>> On Mar 5, 2009, at 9:02 AM, Sahoo wrote:
>>>
>>>> Ken Cavanaugh wrote:
>>>>>
>>>>> On Mar 5, 2009, at 1:20 AM, Jane Young wrote:
>>>>>
>>>>>> Hi Sahoo,
>>>>>>
>>>>>> Corba source code is here:
>>>>>> http://kenai.com/hg/gf-corba-v3-mirror~master
>>>>>
>>>>> That is the master, but right now the version that we are using
>>>>> for getting remote EJB support
>>>>> up is in the staging repo.
>>>> Which is that? Please send me the URL of the repo that contains the
>>>> exact source code used in current GFv3 (b39). I need this for
>>>> debugging.
>>>
>>> I sent that in a previous email: it is
>>>
>>> http://kenai.com/hg/gf-corba-v3-mirror~staging
>>>
>> This looks like a generic URL; I was hoping to see a URL containing
>> some build number in it. I think GFv3 currently uses CORBA
>> 3.0.0-b008, but let's say a previous GFv3 build uses 3.0.0-b007.
>> Where can one check out the source for b007 from?
>
> Kenai does not support that. You need to get the required revision out
> of Mercurial at this point.
> Probably the closest I can get to this is to tag each revision that
> corresponds to a release, then
> you could clone the repo to the required version. At this point, the
> tip is 3.0.0-b008.
>
A tag is good enough. Jane told you didn't tag the repo when you
promoted. Is this true? Can you please ensure to tag going forward?
Sahoo