Creating a Thin Client Administrator or Super Administrator as Part of a Cluster

Introduction

This topic describes how to create a thin client or Super administrator workstation as part of a cluster.

Procedure: Setting up an Administrator or Super administrator workstation on an existing cluster

Follow these steps to set up an Administrator or Super administrator workstation as part of an existing cluster on a Unix or NT server:

1. Install and start up an Administrator or Super administrator workstation.

2. If you have not installed the cluster where this Administrator or Super administrator workstation will be located, install it.

   The Administrator or Super administrator workstation will use the code database that is created as part of the cluster installation.

3. Move the personal database and personal configuration file for the Administrator or Super administrator workstation from its installed location to the new location in the cluster.

4. Edit the personal configuration file and set the SHAREDCFGPATH setting to the SHARED directory for the cluster.

5. If the system configuration file (ofasyscf.cfg) does not exist in the SHARED directory of the cluster, create it.

   For information about how to create this file, refer to Chapter 4.

6. If configuring an Administrator workstation, edit the ofasyscf.cfg file in the shared directory of the cluster and update the [Super] section with the information contained in the [Super] section of the corresponding ofasyscf.cfg file in the shared directory of the Administrator component.